About three years ago I received the wonderful but unexpected gift of a brand new Roweta iron from a friend. It was SO unexpected that I thought she had mailed it to the wrong person and it took her some convincing for me to realize and and accept this wonderful new addition to my hand held appliance collection!
I admit, I have had some struggles most of the time I have had it. For the past three years it has intermittently cooled off in the midst of my ironing task and has been the bane of my existence every time I have used it if I have more than a half dozen items to iron.
Yesterday I lost all patience with it. While I have been wondering if the power source in this run down suite has been to blame, I have had no other issues with lamps or other appliances plugged into that same outlet at other times. So, when in doubt, rustle up the instructions and re-read them.
The first thing I discovered is that I have been adding water to the steamer, setting the ironing temperature and turning the steamer on all in the wrong order....for THREE YEARS and more!! hahahahahahaha Okey dokey then. Got that straightened out and is now a neon direction sign in my brain. However, after shutting off the iron, cooling it down and starting the process all over again, but in the correct order, once again the "Cooling Down" light began flashing less than a minute after I started ironing again. Now what?? So, I decided maybe it needed a cleaning....a decalcification. Out came the little calcium gauge in the top of the iron, I soaked it in vinegar for the requested 4 hours, replaced it in the iron, started the iron again on MAXIMUM according to the cleaning instructions and blasted hot steam through the steam vents on the steam plate to remove the slight build up in the holes. Okay....now all should be well. By this time it was nearly 9pm so I decided to start work on my wrinkled clothes again this morning.
I started well....everything was great. Then a few minutes into the job the cooling light began flashing once again and the heat became reduced quite quickly. Sigh.... NOW WHAT? I had not left the iron hot and unattended for the 8 minutes it needs without movement before shutting itself off. It was not lying on its side, which would have explained the 30 seconds it was hot before it started cooling. I thought the poor iron must have died an early death. HOWEVER!!! As I looked at where it was sitting on my elderly ironing board, with the board pads and covers that are starting to get old and create a few dips in the fabric, I noticed something I hadn't seen before. Yesterday as I was ironing I moved the iron to a different spot near the end of that board than has been its usual placement. Today I put it in the same space when I stepped away to hang up a pair of jeans right before the cool down began.
Well, guess what? That crazy dip I set the iron down on yesterday and again this morning, tilts the iron sufficiently to one side that its "inner workings" decided it had indeed been left lying on its side and once again began cooling the temperature rather rapidly in only 30 seconds. hahahahahaha Hmmmmm.....could this be the problem??
I dug through my kitchen catch-all drawer and came up with a nice, flat, old ironing trivet I haven't laid eyes on for years. I set it on top of the two little peaks on either side of the dip in the ironing board cover, shut down the iron completely, let it cool and then restarted it an hour later.
VOILA!!! I refilled the water tank and pushed the setting buttons and dials properly, the iron heated up properly, I set it on that little trivet every time I put is aside so that it sat straight up on its heel, then I ironed a dozen items with no problems whatsoever. The clothes have never looked better. Once I used it PROPERLY, it is has lived up to its own hype about being one fabulous iron indeed!
Very smart iron; kinda dumb operator. BUT, now I know! YAY!! hahahahaha
No comments:
Post a Comment